
Table of Contents
Purpose
The purpose of a change of bend is to develop the horse’s ability to move smoothly and symmetrically from one bend to the other without losing rhythm, balance, connection or the line of travel.
Technical Definition
A change of bend is the progressive transition from correct lateral flexion and bend in one direction, through a moment of relative straightness, into correct lateral flexion and bend in the opposite direction.
Plain English Explanation
Think of changing the bend as changing which side of the horse is bent to the inside.
Right bend → Straight → Left bend
Rider Aids
Maintain the existing bend until the point where the change should begin.
Gradually reduce the bending aids and ring both reins and both legs towards a more neutral, even influence so the horse becomes momentarily relatively straight.
The new inside leg is now encouraging the horse to bend through its body and continue travelling forward.
The new inside rein asks for a small amount of inside flexion.
The new outside rein, supporting the shoulder and regulating the degree of bend.
The new outside leg helps to control the hindquarters.
What the Judge Is Looking For
When a change of bend occurs within a dressage test, the judge is looking for a horse that changes its positioning smoothly while maintaining the quality of the gait.
The judge wants to see:
- A progressive and clearly established change of bend.
- Correct bend appropriate to the figure.
- Consistent rhythm and tempo.
- Maintained balance.
- Consistent, elastic contact.
- The horse remaining on the intended line.
- Shoulders and hindquarters following the same track where appropriate.
- No resistance through the poll, jaw, neck or body.
- No sudden swinging of the quarters.
- No loss of forward energy.
- Similar quality of bend in both directions.
The change itself should not disrupt the movement being performed.
Common Mistakes
Changing only the neck
The horse’s head and neck turn while the ribcage and body remain positioned in the previous direction.
Pulling with the new inside rein
This can produce excessive neck flexion while allowing the outside shoulder to escape.
Changing the bend too abruptly
The horse is effectively flicked from one bend to the other rather than progressively reorganising its body.
Changing too slowly
The horse remains on the old bend after the geometry of the figure requires the new bend.
Losing the line
The horse drifts or wobbles as the rider changes the aids.
Swinging the hindquarters
The quarters move sideways rather than remaining controlled beneath the horse.
Losing rhythm or tempo
The horse slows, rushes or takes irregular steps during the change.
Confusing flexion with bend
The rider successfully changes the direction of the horse’s nose but not the positioning of the rest of the body.
Rider leaning or twisting
Excessive movement from the rider can disturb the horse’s balance rather than helping it reorganise.
Appears In
The ability to change bend is introduced from the earliest levels of dressage and remains essential throughout the horse’s training.
Training Scale
Rhythm – The horse learns to maintain the same rhythm and tempo while its balance and positioning change.
Suppleness – Change of bend is particularly valuable for developing lateral suppleness and the horse’s ability to move comfortably through both sides of its body.
Connection – The rider must maintain an elastic connection while smoothly transferring the horse from one set of inside/outside aids to the other.
Impulsion – The horse must continue travelling forward through the change rather than slowing or losing energy.
Straightness – Passing through relative straightness between the two bends helps the rider recognise and correct asymmetry, falling shoulders and drifting quarters.
Collection – At basic levels, collection is not the primary purpose of changing the bend. As training progresses, however, the ability to change bend without losing balance or engagement becomes increasingly important within collected work.
Prerequisites
Before introducing more deliberate changes of bend, the horse should understand:
- Basic inside leg to outside rein.
- Simple lateral flexion in both directions.
- Basic bend on a large circle.
- Maintaining rhythm and forward movement.
- Basic steering.
- Straight lines.
- 20 m circles.
- Simple changes of direction.
The horse does not need perfect symmetry before practising changes of bend — changing bend is one of the tools used to develop that symmetry.
Leads To
A reliable change of bend prepares the horse for:
- Figures of eight.
- Serpentines.
- Smaller circles and more complex school figures.
- Counter bend.
- Shoulder-fore.
- Shoulder-in.
- Travers and renvers.
- Leg yield with changes of direction.
- Changes between lateral movements.
- Counter canter figures.
- More advanced combinations requiring rapid changes of positioning.
Ultimately, the ability to change bend while maintaining balance and connection becomes part of the horse’s general manoeuvrability and responsiveness to the rider’s aids.
Exercises to Improve
Figure Eight.
Three-Loop Serpentine
Shallow Loops
Counter Bend to True Bend
Troubleshooting
The horse changes its neck but not its body
You are probably relying too heavily on the new inside rein.
Think about establishing the new bend from the new inside leg into the new outside rein. Keep the amount of neck flexion small and concentrate on controlling the shoulders.
The horse falls through the outside shoulder
Strengthen the support of the new outside rein and ensure the new inside rein is not pulling the neck inward.
Use larger, easier figures until the horse can maintain balance.
The hindquarters swing during the change
Check that you are not suddenly moving or overusing the new outside leg.
Straighten the horse properly before asking for the new bend and make the transition between the aids more gradual.
The horse rushes through the change
Make the exercise simpler.
Use a large figure with a clear straight section between bends. Maintain a steady tempo with your seat and outside rein rather than trying to complete the change quickly.
The horse slows or loses energy
Maintain forward intent with both legs while changing the positioning aids.
Changing bend should reorganise the horse — it should not interrupt the forward movement.
One direction is much harder
This is extremely common.
Return to larger figures and compare what happens in each direction. Look for a shoulder that consistently falls out, quarters that drift, difficulty accepting one rein, or a tendency to avoid bending through one side of the body.
Do not try to force the stiff side into a greater bend. Improve suppleness progressively while maintaining rhythm and relaxation.
The change feels messy and complicated
Slow the process down.
Think:
Old bend → Straight → New bend.
Ride several clearly straight strides between the two bends until both you and the horse understand the aid change. Once that becomes easy, gradually make the transition more seamless.
